G5-100 / 48 Volt SOLID STATE Battery Controller Wind turbine generator

48 Volt SOLID STATE (MOSFET) Controlled! MOSFET's give 10 million cycles + (75 Year life span).

FOR DUMP MODE OPERATION ONLY. #G5 - 36 and 48 Volt battery controller for wind turbine and solar panels - YouTube.

WITH BUILT IN DIGITAL DISPLAY AND INTELLIGENT DUAL PROCESSOR CONTROLLER - No micro relay since it uses MOSFETS! With Original "THEM" Thermodyne Controller. Says THER on the board. Made with real high voltage rated parts.

Some people claim Thermodyne made but only boards. Stamped "THER" are genuine Thermodyne boards. For solar panels and wind turbines. Battery regulator for both your wind and solar battery input power.

This regulator can either dump extra power creating free hot water or heater just cut off extra power to keep your batteries from over charging. HOW POWER DRAW DYNAMICS WORKS. This controller was specially developed for wind turbines and works well on solar too - Get just this one battery controller to do it all! Protect one complete battery bank within power range.

MUST BE CONNECTED TO BATTERY AT ALL TIMES! THE RAW POWER FROM A TURBINE ONLY COULD BURN OUT THE IC CHIP.

THE BATTERY PROTECTS THE CURCUIT FROM HIGH VOLTAGE SPIKES. WHEN CHANGING OUT BATTERY OR INSTALLING YOUR #G5. REMOVE THE WIND-TURBINE FOR BATTERY CIRCUIT FIRST. WHEN INSTALLING HOOK TO YOUR BATTERY FIRST!

WHEN UN-INSTALLING REMOVE FROM BATTERY LAST! AVOID VOLTAGES OVER 75 VOLTS! BEING GROUNDED TO A LEAD ACID BATTERY. WILL BUFFER ALL VOLTAGE DOWN TO 66 VOLTS.

Used to prevent battery over. Charging on Wind -Solar - Hydropower. A battery regulator diverts excess power to. Over to some other useful device when ever your battery is full. Automatically resets and starts over keeping your battery safe.

Use the this excess power to make free hot water or to recharge an auxiliary battery bank, too many uses to mention! Draws almost ZERO power while sensing! 99.998% electrically efficient while sensing!

Versatile raised steel mounting plate. Measures 9" long by 3" wide by 3 tall. Works best in large multiple battery banks. Draws only trace power while.

Works for all Wind Turbines, Solar panels and Hydro batteries. No grounded IGBT's or MOSFETS -Lighting strike proof isolation. Does not waste electricity while. DUMP -LOAD battery controller (dump load resistor not included).

The modern way to monitor your battery from over charging is to have a diversion load that performs another task such as heating water when your battery is in danger of over charging. Shutting down the output of your wind turbine or your other renewable energy devices is old school thinking. Now-a-days most people dump their excess power into some other legitimate device optimizing their energy independence. Hot water from your excess power can be used for radiant heating in the winter or even in the hot summer months for washing cloths or dishes and for bathing.

You will always find a need for hot water in your life. "Electromechanical units ours are impervious to lighting, EMP and static electrical discharges". "Simple and ultra-reliable"- A BULLET PROOF SYSTEM. We are a THERMODYNE DEALER.

This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits". The seller is "wind_turbine_generator" and is located in this country: US. This item can be shipped worldwide.

Model: g5100nb112
Non-Domestic Product: No
Custom Bundle: No
Modified Item: No
Type: Wind turbine battery controller
MPN: g5-100-nb
Brand: windturbineusa.com
Application: Agriculture/Farming, Aquaculture, Automotive, Back-up Power, Camping/Hiking, Commercial, Electronics, Home/Garden, Irrigation, Marine
Country/Region of Manufacture: United States
Voltage: 48