Missouri Wind and Solar FREEDOM PMG. Specifically designed for wind turbine use. New for 2018 - Keyed shaft with special hub spacer stabilizer that bolts to our Missouri Wind and Solar wind turbine blade hubs.Our Missouri Freedom I and Freedom II PMGs feature have a smooth and easy rotation! We've designed new technology into our internal parts to get your wind turbine, hydroelectric, and motor mounted Freedom Series PMG to start-up easier and make more power! This is a high amp model. It has a 14 magnet rotor inside with the.
Skewed stator core for easy turning and. Comes with 1 rectifier, hub spacer stabilizer & cam lock washer. Keyed stainless steel shaft for added blade & hub security.
Up to 1600 watts of output. 6 mph cut in speed. Our newest innovation in power generation!Produces battery voltage at approximately 266 RPM. Produces twice (2X) the battery voltage at approximately 506 RPM. Produces four times (4X) the battery voltage at approximately 960 RPM. The answer is simply more copper! More copper equals more power - each Freedom PMG stator contains twice as much copper than any Delco style PMA.
Additional reasons why the Freedom PMG is better than ANY Delco or other modified car alternator PMA. Some modified alternators use power to make power.Freedom PMGs use no input power. PMAs use a thin aluminum housing and the stator is not pressed in. The Freedom PMG features a very thick aluminum housing and a pressed in stator that helps with proper alignment and durability. PMAs have only two mounting holes. The Freedom PMG has four of them bolted tightly against the mounting bracket for secure mounting.
Alternators and some PMAs have a weak rear bearing. The Freedom PMG utilizes two heavy duty bearings.Most car alternators and PMAs that are re-purposed use low grade/high iron electrical steel which can create a lot of heat. The Freedom PMG uses high grade electrical steel and is optimized for efficient cooling. NO COGGING, easy to turn - Cut in speed of 6 MPH. Skewed stator core with high grade electrical steel and heavy duty copper windings. 17 mm stainless steel shaft compatible with all Missouri Wind and Solar hubs.
2x thick polished aluminum case. Zinc plated 14 rare earth neodymium magnet rotor. No brushes to fail or replace. Two heavy duty bearings in front and back.Fits delco bolt patterns and mounts up to our standard mounting bracket. Keyed shaft with removable key. Hub spacer stabilizer with bolts for hub mounting. 1 15/16 on center between mounting holes. Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better. The item "Freedom PMG 24 Volt Wind Turbine Permanent Magnet Generator Alternator PMA" is in sale since Wednesday, December 16, 2015. This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits". The seller is "missouriwind" and is located in Seymour, Missouri. This item can be shipped worldwide.