400W AC 24V 5-Blades Lantern Wind Turbine Generator Vertical Axis Wind Power. Using reinforced nylon fiber on wind wheel blad. And the aerodynamic lantern shape design, the.Coefficient of wind energy utilisation is increased, so as increased annual electricity generation capacity. Low start up wind speed, high efficiency, small size, low vibration. The shell is made of stainless steel die-casting, with double bearing carrier, anti-typhoon capacity is. Hree-phase permanent magnet synchronous motor. Efficient AC generator with high performance NdFeB permanent magnet. A fully integrated voltage regulator that automatically shuts down when the battery is fully charged. The fan is controlled by MPPT intelligent microprocessor, which can. Effectively adjust current and voltage. The vertical wind turbine is quieter than horizontal axis turbine. Double bearings make it more stable and not easy to shake when wind generator is running.
Wind turbine can start by breeze and adapt to 360°wind, no yaw system is needed. For home use, For monitoring use, For. / marine use, For wind solar. Colour: Red Rated power: 400 W Rated voltage: 24V Start-up wind speed: 2m/s Rated wind speed: 11m/s Survival wind speed: 45m/s Wind wheel diameter: 35.23 inch Blade length: 23.62inch Weight: 12.5kg Number of blades: 5 PCS. Blade Material: Nylon Fiber Cabin Material: Die Casting Aluminum Alloy Generator Type: 3-Phase AC Permanent Magnet Generator Controller system: Electromagnetic.
Controller brake system: overspeedthree-phase short circuit brake. Wind Direction Adjustment: Adapt to 360°wind Operating Temperature: -40 80? The wind turbine is made entirely of high quality aluminum and stainless steel fittings.
The wind turbine blade is made of high quality nylon fiber with 30% carbon fiber and anti-UV anti-corrosion material, which has strong flexibility and high sa/fety factor. The optimized starting shape design improves the wind energy utilization rate and increases the power generator. Double bearings make it run with low vibration and quiet.It can also make wind power generation start from a low wind speed, rotate steadily and silently. Intelligent micro-processing controller effectively regulates current and voltage. The surface of the wind turbine is coated with a special process that provides excellent resistance to oxidation and corrosion under any harsh conditions, as well as excellent corrosion?
Three-phase permanent magnet synchronous motor. Efficient AC generator with high performance NdFeB permanent magnet and unique magnetic circuit design, so that the starting torque is very small, can effectively ensure the wind starting capacity of the fan. The wind turbine is controlled by MPPT intelligent microprocessor, which can effectively adjust current and voltage. The machine will shuts down, when the battery is fully charged. Take out the wind turbine, put the wind turbine on the tower and align it with the flange hole.
Mount the four flat gaskets on the four bolts, then insert the bolts into the holes corresponding to the flange. Tightening the screws by hex key. The three wires of the wind turbine are connected to the transmission cable, each pair of wires is not less than 1.18 inch, and the tape at the connection end is at 3.94 inch. Connect the wind turbine's cable to the controller and the battery must be connected to the controller before wiring. 1x Wind Turbine (tower tube isn't included).
Appication: For home use, for monitoring use, For. There is no need to add another rectifier, it is built-in rectifier. (without control function, it means without brake function) red connected to positive pole, blue connected to negative pole, yellow green ground wire, can not be connected, can be used after wiring.This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits". The seller is "pernew19" and is located in this country: US. This item can be shipped to United States.