2000 Watt Freedom II Hydro PMG Permanent Magnet Generator. Missouri Wind and Solar Freedom II Hydroelectric PMG (permanent magnet generator). Our Freedom I and Freedom II PMGs have a smooth and easy rotation! We've designed technology into our internal parts to get your wind turbine, hydroelectric, and motor mounted Freedom Series PMGs to start-up easier and make more power!
Our Freedom II HYDRO PMG permanent magnet generator is specifically designed for hydro or gas engine use. Produces 12 volts at approximately 266 RPM. 24 volts at 500 RPM. 48 volts at 900 RPM. No resistance will be encountered until you reach the RPMs needed to exceed your battery voltage, making our Hydro PMG a powerful 12, 24, and 48 volt charger.The answer is simply more copper! More copper equals more power - each Freedom PMG stator contains twice as much copper than any Delco style PMA. Additional reasons why the Freedom PMG is better than ANY Delco or other modified car alternator PMA. Some modified alternators use power to make power. Freedom PMGs use no input power. PMAs use a thin aluminum housing and the stator is not pressed in.
The Freedom PMG features a very thick aluminum housing and a pressed in stator that helps with proper alignment and durability. PMAs have only two mounting holes.
The Freedom PMG has four of them bolted tightly against the mounting bracket for secure mounting. Alternators and some PMAs have a weak rear bearing. The Freedom PMG utilizes two heavy duty bearings. Most car alternators and PMAs that are repurposed use low grade/high iron electrical steel which can create a lot of heat.
The Freedom PMG uses high grade electrical steel and is optimized for efficient cooling. NO COGGING, easy to tur.
Skewed stator core with high grade electrical steel and heavy duty copper windings. 17 mm stainless steel shaft compatible with all Missouri Wind and Solar hubs.
2x thick polished aluminum case. Zinc plated 28 rare earth neodymium magnet rotor. For charging 12 volt battery banks. Fits delco bolt patterns and mounts up to our standard mounting bracket. 1 15/16 on center between mounting holes.
Shaft thread & size: M16 - 1.5 (M=metric, 1.5 = metric thread pitch). This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits". The seller is "mezalon123" and is located in this country: US. This item can be shipped to United States.