Freedom II Hydro PMG 12 volt. Permanent magnet alternator generator (pmg). New for July 2016: Our Freedom I and Freedom II PMGs now have a smoother and easier rotation! We've designed new technology into our internal parts to get your wind turbine, hydroelectric, and motor mounted Freedom Series PMG to start-up easier and make more power!This is a high amp model. It has a 28 magnet dual rotor inside and. Our skewed stater core for easy turning and. Charge 12 volt battery banks.
Up to 2800 watts output. This PMG is for Hydro or gas or steam engine use. Missouri Wind and Solar FREEDOM II HYDRO PMG (permanent magnet generator). Our newest innovation in power generation.
Produces 12 volts at approximately 266 RPM in parallel. 133 RPM in series - performance on 12 volt is good. Produces 24 volts at approximately 506 RPM in parallel.
253 RPM in series - performance on 24 volt is better. The answer is simply more copper! More copper equals more power - each Freedom PMG stator contains twice as much copper than any Delco style PMA.Additional reasons why the Freedom PMG is better than ANY Delco or other modified car alternator PMA. Some modified alternators use power to make power. Freedom PMGs use no input power. PMAs use a thin aluminum housing and the stator is not pressed in. The Freedom PMG features a very thick aluminum housing and a pressed in stator that helps with proper alignment and durability. PMAs have only two mounting holes. The Freedom PMG has four of them bolted tightly against the mounting bracket for secure mounting.
Alternators and some PMAs have a weak rear bearing. The Freedom PMG utilizes two heavy duty bearings. Most car alternators and PMAs that are re-purposed use low grade/high iron electrical steel which can create a lot of heat.
The Freedom PMG uses high grade electrical steel and is optimized for efficient cooling. NO COGGING, easy to turn - CUT-IN SPEED IS 6 MPH. Comes with two heavy duty rectifiers & one hub spacer stabilizer. Skewed stator core with high grade electrical steel and heavy duty copper windings. 17 mm stainless steel shaft compatible with all Missouri Wind and Solar hubs.
2x thick polished aluminum case. Zinc plated 28 rare earth neodymium magnet rotor. For charging 12 volt battery banks. Specifically designed for wind turbines. Fits delco bolt patterns and mounts up to our standard mounting bracket.1 15/16 on center between mounting holes. Products may be slightly different than the ones pictured.
If our supplier runs short of the products shown, we will substitute them for the same quality or better. The item "Freedom II PMG Hydro Permanent Magnet Generator with Fan & Pulley" is in sale since Wednesday, December 16, 2015.This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits". The seller is "missouriwind" and is located in Seymour, Missouri. This item can be shipped to United States, Canada, United Kingdom, China, Mexico, Germany, Japan, Brazil, France, Australia, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Greece, Portugal, Cyprus, Slovenia, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Austria, Bahamas, Israel, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay.