Wind Turbine Generator

9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar


9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar
9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar
9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar
9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar
9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar

9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar    9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar

Missouri Wind and Solar Freedom 3 Fully Sealed. 12 Volt 9 Blade 1600 Watt Wind Turbine. Freedom 3 Sealed PMG - For Land or Sea. Our Missouri Freedom Wind Turbines are hot-dipped galvanized with zinc-plated hubs!

Resists Rust - No need for painting or special coating for up to 50 years under normal conditions. Highly Anticipated - All New for 2019, Our Freedom 3 Sealed PMG is Perfect for Marine Use or Anywhere a Wind Turbine Can Be Mounted. Missouri Wind and Solar Freedom 3 PMG.

Is fully sealed to create a water resistant motor for wind and hydro power. Ruly well thought out with years of R&D behind the production.

We've had the motor installed at our store in Seymour, Missouri with great results and have even run it through our wind tunnel test at 55 MPH. The fully sealed motor is. Perfect for marine environments but can be used anywhere a wind turbine can be mounted. Just like the Missouri Wind and Solar. The Sealed PMG contains more copper than typical PMAs on the market.

More copper equals more power output! Our custom made skewed stator reduces cogging and allows startup in lower wind speeds.

Fully Sealed 1600 Watt Freedom 3 PMG. 3 phase bridge rectifier for converting to DC output. (see below for more specifics).

Heavy duty hub spacer/stabilizer with slot to fit keyway. Specially designed to channel water away from the PMG housing. PMG mounting bracket and heavy duty Stars & Stripes wind turbine tail.

Mounting Bracket fits on 1.5" schedule #40 or #80 pipe (1 7/8" OD) and allows for easy turning. Tail fin measures 9 3/4 inches wide x 28 3/4 inches tall. Cut from 16 gauge steel. Hot dipped galvanized weather resistant finish.

Comes with 9 Raptor Generation 4 carbon fiber composite blades. Aerodynamically tapered blades for maximum output.

Raptor Generation 4 Blades are Made in the USA. Assembled blades and hub make 61 inch swept area. Overall assembled length: 37 inches.

No slip rings to fail or replace. Simple and effective, our wind turbines use a wire tension system which will last a lifetime. The single power transmission cord never twists because the wind never spins the turbine around in the same direction hundreds of times. Typically, the wind only comes from two directions.

It has yet to be an issue with any one of the thousands of turbines we have distributed nor any of the wind turbines at our Seymour, Missouri store. Fully Sealed Freedom 3 PMG Features. To withstand wear and abuse.

With additional labyrinth style seal. Case with a rough, natural finish which means.

More surface area to speed cooling and improve output performance. Keyed shaft and hub stabilizer. That bolts on to the blade hub to prevent slipping and improve safety. Hub stabilizer that channels water away.

From entering through the front of the housing. To keep water from seeping into the case. No marine varnish or painting required.

17 mm stainless steel shaft compatible with all Missouri Wind and Solar hubs and blade sets. Custom hub spacer/stabilizer with keyway and bolts for attaching to Missouri Wind and Solar blade hubs. Zinc plated 14 rare earth neodymium magnet rotor. No brushes to fail or replace.

Arge, heavy duty bearings in front and back. Fits delco bolt patterns and mounts up to our standard mounting bracket.

1 15/16 on center between mounting holes. PMA and PMG cases should not be painted or coated. This prevents heat from leaving the motor and reduces efficiency. If you have an open faced motor like our Freedom single and dual PMGs, you can marine varnish the interior components. Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better. The item "9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar" is in sale since Friday, January 18, 2019. This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits". The seller is "missouriwind" and is located in Seymour, Missouri.

This item can be shipped to United States, Canada, United Kingdom, China, Mexico, Germany, Japan, Brazil, France, Australia, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Greece, Portugal, Cyprus, Slovenia, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Austria, Bahamas, Israel, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Antigua and barbuda, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Saint lucia, Montserrat, Turks and caicos islands, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay.

  1. EAN: Does not apply
  2. Custom Bundle: Yes
  3. ISBN: Does not apply
  4. UPC: Does not apply
  5. Modified Item: No
  6. Wind Turbine Blade Color: Black
  7. Wind Turbine Blade Material: Carbon Fiber Composite
  8. Non-Domestic Product: No
  9. Blade Material: Carbon Fiber
  10. Axis Orientation: Horizontal
  11. Type: Wind Turbine Generator
  12. Color: Black
  13. MPN: FREEDOM_III_G4_9B_BLACK
  14. Number of Blades: 9
  15. Rotor Diameter: 62 Inches
  16. Brand: Missouri Wind and Solar
  17. Application: Back-Up Power
  18. Wattage: 1600
  19. Current Type: AC/DC
  20. Bundle Description: Includes wind turbine blades, blade hub, locking collar, zinc plated yaw bearing, galvanized mounting bracket, clamps, galvanized tail arms and tail fin, and the nuts and bolts for assembly.


    9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar    9 Blade 1600 Watt Sealed Wind Turbine Black Blades Missouri Wind and Solar