1645 Watt SUPERCORE SC PMA 12 VDC Wind Turbine Permanent Magnet Generator N

Designed for use with our 34.64 KT propeller (blades) and with these blades can make up to 1645 Watts peak power in high winds (Rated as peak) All voltage ranges (VR) are based on use for battery charging with wind power! This PMA's is recommended for wind turbines only!

Peak at about 2000 RPM. (3 PHASE AC COIL ON THE INSIDE AND DC CONNECTIONS ON THE OUTSIDE) For PMA's / PMG's for engines / hydro use our line of #PC1212 or #QC1212 models. Video will open in a new window. Missouri Freedom PMG with Thermodyne Super Core rotor inside. Thermodyne 1600W Wind Turbine Review.

Copy this link into Safari. TREX blades on SC12 PMA Wind Turbine windgeneering.

What's better, AC or DC wind turbine PMA's / PMG's. 1725 Watts peak / 2200 RPM at peak load. In a zone 7 area this turbine can make up to 200% more power or 12.60 kWh.

Wind Zones are defined by m/s Wind Zone 1 0 4.4 m/s (Wind not recommended, go solar in this wind zone) Wind Zone 2 4.4 5.1 m/s Wind Zone 3 5.1 5.6 m/s Wind Zone 4 5.6 6.0 m/s Wind Zone 5 6.0 6.4 m/s Wind Zone 6 6.4 7.0 m/s Wind Zone 7 7.0 9.4 m/s (20-22 mph) Make sure your equipment can handle the peak voltages of each model. Batteries are good at absorbing high voltages as long as they do not go over their voltage limits and that is why are battery regulators are critical to match with our turbines. We sell many models as long as the voltages match.

You will receive only the most modern magnet core with deep saturation slotted magnets providing deep reaching pole power into the stator coil for maximum amperage. Includes a real original SUPER-CORE PMA. The reason why they cost less.

Is that they are utilizing an old fashioned. The modern type PLATE AND GROOVE rotor that we have developed is the most celebrated and also the most copied type which we pioneered. The important part is that PLATE AND GROOVE makes power at MUCH LOWER RPM's than the older and traditional Clam type rotor designs that do not provide deep magnetic saturation of the Stator coil offering 600% more power in low RPM scenarios over Clam type designs. In small wind turbines this is VERY important to make your power in the LOWER RPM ranges. Spend a little more and get a LOT more BANG-FOR-YOUR-BUCK!!!

From the beginning GM designed the Delco to run. WET and even tested them to operate. Designing an alternator that can survive at 375 degrees F.

Under the hood of a car operating with rain water coming through the. Radiator and from water puddles is. Over 100,000,000 10/12si's were produced by Delco and after-market vendors! Parts for this legendary'work-horse' will be available for the next 50+ years. World's most supported and well recognized model!

Our Magnets are on an angle. We make our own brand new. Our PMA's are built from the ground up using only 100% ALL new parts! (Including the rotor pole shoes and stator coil stacks).

Our NEW rotor poles are balanced to within. 002 grams for SMOOOOOTH rotation!

Get the original - MADE IN THE USA! The item "1645 Watt SUPERCORE SC PMA 12 VDC Wind Turbine Permanent Magnet Generator N" is in sale since Thursday, December 21, 2017. This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Wind Power Supplies\Wind Turbines & Kits".

The seller is "wind_turbine_generator" and is located in Lancaster, California. This item can be shipped to United States.

Country/Region of Manufacture: Unknown
MPN: Wind Turbine Generator
Brand: windmill thermodyne
Model: Wind Turbine Generator T2